C1400 BMW Fault Code
Check C1400 OBD Fault Code ReasonFuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value.
Low fuel pressure Damaged BMW FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.
C1400 Code Symptoms :
If your C1400 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C1400 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.
Diagnosis And Repairing C1400
C1400 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.
How to fix C1400 code ?
- 1Camshaft Position Sensor circuit poor electrical connection
- Faulty Camshaft Position Sensor
- Faulty Air Flow Meter
- Faulty TCM or TCM programming
Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C1400, so consult the manual to locate the brake fluid reservoir.
Bear in mind that a low fluid level can set code C1400 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.
